|Power:||10KVA 15KVA 20KVA 30KVA 40KVA 60KVA 80KVA 100KVA 120KVA 160KVA 200KVA||Capacity:||8KW 12KW 16KW 24KW 32KW 48KW 64KW 80KW 96KW 128KW 160KW|
|Efficiency Smart Mode:||Up To 98%||Protection Degree:||IP20|
|Frequency Range:||45-65Hz||Rated Voltage:||380/400/415 Vac Three-phase|
200KVA Low Frequency UPS,
Uninterruptible Low Frequency UPS,
160KW Low Frequency Online UPS
210KVA Modular UPS Low Frequency UPS Online 3 Phases Uninterruptible Power Supply Ups 380V
High intelligence and reliable power supply:ZGD330 provides maximum protection for vital mission-critical networks, security applications (electro- medical)and industrial applications thanks to its outstanding mechanical and electrical design.
The load is powered continuously by the inverter with a filtered, stabilized and regulated sine wave supply. The input and output EMI filters considerably increase the immunity of the load to mains disturbances and surges.
The ZGD330 uses on-line double conversion technology (VFI) with isolation transformer on the inverter output.
The ZGD330 is supplied with Watch & Save 3000 software as standard and can be remotely monitored using the Power Net Guard system from anywhere in the world. Additional battery extension packs allow the standard battery routine to be extended up to several hours.
Local area Network(LAN),
Minimum impact on supplies easy sources:
Input current distortion <4% for the ZGD330 with filter with sinusoidal absorption to remove the risk of resonance with other input supply users or phase shift capacitor sets. The absorbed current distortion is independent of input supply parameters such as impedance. This enable ZGD330 to deliver maximum performance levels regardless of the installation environment. With these input features ZGD330 can achieve significant savings in terms of sizing and power supply sources isolation transformers and generators over less sophisticated power systems.
Maximum battery care:
Battery deep discharge protection;
Temperature compensating charger;
Built-in automatic and manual battery test feature.
Simple to install:
Capability to install the UPS into any distribution system(neutral not required on rectifier input);
Capability to separate the rectifier/bypass power networks and to power these from two separate sources, without Galvanic isolation (Necessary on UPS without an output transformer).
Extremely high short-circuit current to ensure compatibility with the most difficult transformer applications (lighting, drives and industrial processes) and an isolation transformer on the inverter output;
Full microprocessor control with no-break static and manual bypasses;
0.8 power factor make ZGD330 suitable for powering ICT and Industrial loads;
High level diagnostics: event log with 128 messages, states, measurements and alarms - available from the built-in LCD with several languages;